Servicing; Cleaning; Fitting The Clipper Blade - Heiniger CORDLESS Betriebsanleitung

4 Servicing

The charger is maintenance-free. Before cleaning, pull the charger's plug out and remove the
battery from the machine.

4.1 Cleaning

Cleaning the Clipper Head and Clipper Blades
After clipping, remove all oil from the machine by rubbing it down with a dry cloth and care-
fully clean the clipper head and clipper blades with a dry brush. Then oil the parts to prevent
rusting. Even the smallest rust spots on the blades can adversely affect clipping or make it
completely impossible.
Cleaning the Charger and Battery
Only clean the charger and battery with a dry cloth or a cloth slightly dampened with soapy
water (not dripping wet).
Do not use any solvents since they can damage the charger and the battery.

4.2 Fitting the Clipper Blade

A pair of clipper blades consists of a lower blade (Illustration 8, Item 2) and an upper blade
(Illustration 8, Item 1). When fitting the blades care should be taken to ensure that the correct
surfaces come to rest against each other. The blades are fitted as follows:
Illustr. 8
Loosen the pressure adjusting screw (Illustration 9) and place the machine on a hard surface
so that the blade fixing screws lie uppermost.
Loosen the two blade fixing screws (Illustration 10) and remove the two old blades.
Illustr. 9/10
Ensure that the new clipper blades are clean. Particular care should be taken to ensure that the
ground surfaces are free of dirt; if not, even newly ground clipper blades will not clip satisfac-
torily.
Place the new upper blade in the guide points of the driving carrier; then place a few drops of
oil on the ground surfaces (Illustration 11). Now push the new lower blade between the loose-
ned screws (Illustration 12).
What is now important is that you adjust the blades against each other in such a way that the
Illustr.
ground surface of the lower blade projects approx. 1.5 - 2.0 mm beyond the tips of the upper
11/12/13
blade (Illustration 13).
Once you have adjusted the clipper blades, set the position of the lower blade and tighten up
the blade fixing screws.
Instruction manual CORDLESS 11