Safety Recommendations; Conditions Of Guarantee, Faults/Defects - Melitta 190 Gebrauchsanleitung

Instructions concerning safety
b
Keep instructions for use near the machine, so that it is
always possible for the operator to operate the machine
correctly.
b
Do not pull the filter out of the machine if the filtering
process has not yet finished. After the filtering process is
over, please be aware of idle running of the unit: danger
of scalding.
b
Only use the glass jug for hot drinks. Do not clean with
hard devices. Do not use for cooking beverages. Not
suitable for use in micro-wave oven.
b
Do not heat up the jug if empty or wash in dish washer
at a temperature of over 92°C.
b
Do not hold the full jug above persons.
b
Do not touch the warm holders. Risk of burning!
b
Switch off the warm holders as soon as the glass jugs are
empty.
b
Melitta SystemService is not liable for damages which
occur due to lack of maintenance, improper handling of the
machine, or installation of parts which are not genuine
Melitta parts.
b
Melitta SystemService reserves the right to carry out
alterations at any time without prior notice if these
alterations are necessary for technical improvement.
b
Prior to opening the machine pull the plug out of the
socket.
b
Switch off the water supply on site if the machine is not
to be operated for a longer period of time.
b
The machine must not be operated outdoors.
Instructions for eliminating possible faults/defects
Fault/Defect
Servicing indicator lamp (1)
starts to burn,
filtering process is interrupted
Retarded filtering process
Water dosing not according to
selected programme
Coffee does not taste good
Coffee too cold
Coffee too hot
HW-unit 193 W / 197 W
does not heat up
HW valve does not close, drips
Please contact MSS service personnel if other faults/defects than the above mentioned occur.
Cause
b Excessive build-up of limescale in instantenous
water heater
b Temperature control defective
b Water supply line to heater is clogged
b Defective switch
b See above mentioned
b Very fine ground coffee, very soft water =
filter pores clog up
b Machine is not on an even surface =
the water level in the fresh water container
is not as indicated
b Water pressure is not correct
b Solenoid valve dirty
b High rate of chlorine in water
b Contains residual descaling or dish washing agent
b Coffee has been stored for more than one hour
b Poor quality of the supplied coffee powder
b No lid on the jug
b Small quantity of coffee has been kept in the
machine too long
b Temperature limiter has responded
b Limescale in closing area of valve
Conditions of guarantee
We guarantee for the perfect working of this machine / installa-
tion over a period of 12 months beginning at date of invoice.
If assembly is performed by us or a company authorized by
us then warranty beginning is date of assembly. Throughout
this period all defects due to faulty material, poor design, and
faulty construction work will be repaired free of charge by us,
provided that the machine was operated and maintained
properly. Parts which have to be exchanged remain property of
MSS and are to be made available to us.
We are not responsible for damages caused by lack of
maintenance and care even if they occur during the period of
guarantee. Damages caused by unauthorized or improper repair
work or installation of not genuine Melitta spare parts are also
not covered by this guarantee. All parts made of porcelaine or
glass or wearing parts are also excluded from our guarantee
Wearing parts are: sealings/gaskets, valves, faucets, heating
resistors, coat of lacquer, switches and thermostates/thermo-
regulators. Claims for damages under conditions of guarantee
can only be accepted if a written report has been handed in
by our customer service and an inspection of the machine has
taken place in our work.
Elimination
Descale machine at the end of the
filtering process
Request service engineer
Clense the tubes and sieves
Request service engineer
Choose coarser ground brand of
coffee
Even out uneven patches of the sur-
face beneath the machine, change
position of the machine
Check water pressure and adjust by
means of valve/pressure pump
Request service engineer
Inform Melitta service personnel to install
water filter
Rinse machine or jug with water
Consume fresh coffee as soon as
possible
Speak with coffee supplier
Insert lid on jug
Consume freshly filtered coffee as
soon as possible
Remove cap (16), press in the limiter
situated beneath the cap, request for
service engineer
Operate switch several times
Request service engineer
21