Closing The Casing; Connecting The Pc - Auerswald COMpact 5200 Betriebsanleitung

Commissioning (COMpact 5200R/5500R)
Inserting a Module
1. Slide the module into the board guides (A)
with the component side pointing to the left.
2. Press the module backward until the board
lock (B) clicks into place.
Removing a Module
1. Unlatch the board lock, for example with your
right thumb.
2. Remove the module with your other hand.

Closing the Casing

Requirements:
• Screw driver (Phillips)
1. Remove the dummy panels at those points where modules
have been inserted by pressing them outward from the inside,
for example with your thumb.
Note: Dummy panels that have been removed can be reinserted
any time. For a COMpact 2FXO module with only two RJ-45
sockets you can break a dummy panel into halves at intended
breakpoint at the centre and reinsert one of the halves.
2. Place the front panel onto the casing.
3. Secure the front panel with its four screws.

Connecting the PC

Requirements:
• Available network socket on the PC or in the network of the PC
1. Insert one end of the accompanying network cable into the network
socket on the PC or in the network of the PC.
2. Insert the other end of the network cable into the RJ-45 socket of the
CPU module.
48
COMpact 5200/5200R/5500R - Instructions V02 01/2018