Initial Instructions - Migatronic DELTA 180 E PFC Betriebsanleitung

Generally
1. Main switch
This switch turns the machine on and off. When the
main switch is switched off, a clicking sound may
appear from the machine whilst the green LED on
the front (7) flashes. This is normal and is not an
error.
2. Mains cable
Entry point for mains voltage supply cable
3. Welding cable sockets
DC positive and negative welding current outlet
sockets. Electrode cable to be fitted in positive or
negative outlet socket in conformity with the
polarity of the electrode, and earth return cable to
be placed in remaining socket.
4. Welding current control
This knob is used for adjustment of the welding
current.
5. Arc-power
The arc power function is used to stabilise
the arc.
This can be achieved by increasing
welding current during the short-circuits.
Arc power can be adjusted between 0 and 100% of
the welding current setting. Please be aware of the
fact that a to high Arc Power can result in
increased welding spatter.
INITIAL INSTRUCTION
6. Overheating
7. The green LED is alight when the machine is
8. Internal / external control
9. Connection of remote control
14
The yellow LED will alight if the machine is
disconnected due to overheating. Overheating
arises if the machine is overloaded. The machine
automatically reconnects when the temperature
has fallen, and the yellow LED will switch off.
Warning:
When the machine is overheated, it is important to
place the electrode holder/torch so as to avoid the
risk of establishing the arc when the machine
reconnects automatically.
switched on
Selection between internal control
where current is adjusted on the
control knob (4) or external control
where the current is adjust on a remote control.
When external control is selected, the internal knob
(4) is used for setting max. current, and welding
current is now adjustable from 25 A up to the set
current by means of the remote control.
Connection of remote control
(article no.: 78815035 (5m) or 78815036 (10m))