Description - Hilti AG 125-A22 Bedienungsanleitung

Obligation signs
Wear eye Wear a hard
protection
en
Wear Read the
breathing operating
protection instructions
before use.
Symbols
Returning Volts
materials for
recycling
Revolutions Revolutions
per minute per minute

2 Description

2.1 Use of the product as directed
The power tool is designed for cutting and grinding metal and mineral materials without use of water.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
Do not use the battery as a power source for other unspecified appliances.
Working with metals: Cutting, grinding.
Working with mineral materials: Cutting and slitting using the corresponding guard (DC-EX 125/5"-C), grinding using
the corresponding guard (DG-EX 125/5").
Use only discs (abrasive grinding discs, abrasive cutting discs, etc.) that are approved for use at a speed of at least
11,000/min, with a maximum thickness of 6.4 mm (grinding discs) or 2.5 mm (cutting discs) and a diameter of max.125
mm.
Use only synthetic resin-bonded, fiber-reinforced grinding discs or cutting discs approved for use at a permissible
peripheral speed of at least 80 m/sec.
The power tool may be used only for dry cutting or grinding.
When grinding stone, a vacuum cleaner equipped with the appropriate filter, e.g. a suitable Hilti vacuum cleaner, must
be used.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
Observe the national health and safety requirements.
Modification of the power tool or tampering with its parts is not permissible.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not
as directed.
18
Wear ear
hat protection
Direct
current
Diameter
Location of identification data on the power tool
The type designation and serial number can be found
on the type identification plate on the machine or tool.
Make a note of this data in your operating instructions
and always refer to it when making an enquiry to your
Hilti representative or service department.
Wear
protective
Type:
gloves
Generation: 01
Serial no.:
Rated speed