Installing The Wall Holder; Operation - Unold 87396 Bedienungsanleitung

Caution! The appliance is very hot during and after operation!
Never open the housing of the appliance. There is danger of
electric shock.
For safety reasons never use the appliance close to or in a bath-
tub or washbasin or any other container filled with water. If the
hair dryer is used in a bathroom, unplug it from the wall socket
after use, since nearby water presents a danger even when the
hair dryer is switched off.
The manufacturer will not be liable in the event of incorrect assembly, improper or incorrect use or if
repairs are carried out by unauthorized third parties.

INSTALLING THE WALL HOLDER

1. Caution: If you want to install the wall holder in damp rooms, such as bath-
rooms, ensure that there is an adequate distance to the bathtub, sink and
other vessels filled with water. The distance in this regard must be at least
1.5 meters to ensure safe operation.
2. First check whether an electrical outlet is within reach at the desired instal-
lation location.
3. Attach the wall holder with three screws. If necessary use dowel plugs to
securely attach the wall holder. Please use the attached drill template for
easy installation.
4. Note: at the back of the wall holder there is a small tab. If you mount it first
with a screw on the wall, you can simply mount the wall holder and then
secure it with the other two screws on the right and the left hole.

OPERATION

1. Ensure that the on/off switch is on "0".
2. Plug the power plug of the wall holder into an electrical outlet (220–240 V~,
50/60 Hz).
3. Take the hair dryer out of the wall holder.
4. Switch the appliance on via the On/Off switch.
5. Select the desired speed level. The following settings are available:
0 = Off
1 = Moderate air flow, for drying and styling hair
2 = Powerful air flow and heat flow, for fast drying of hair
18
Copyright UNOLD AG | www.unold.de