Programming A Bid Chip / Key; Programming Procedure Example For A "Lipo - ROBBE Power Peak Twin EQ-BID Bedienungsanleitung

8. PROGRAMMING A BID ChIP
As soon as a BID chip/key is connected to the charger via adaptor lead, from the start
display or from any other menu on the set-up level, the charger switches to the BID mode
for display of or for programming a BID chip/key. When the transducer is active, a short
acoustic beep will be heard. The same applies if the charger is switched on with a chip/
key connected.
9.1

PROGRAMMING PROCEDURE ExAMPlE FOR A "lIPO"

Operating Instructions
Power Peak ® Twin EQ-BID
The adjoining illustration shows this condition. The status
line shows the BID system, teh second line displays all
the stored battery data. The other lines show the charge-/
discharge condition of the battery. The last line shows the
programming date as well as first use of the battery.
To program the BID-chip/key data, navigate the indicator
arrow fully to the lower line with the "DEC" button. Via the
visible line "START & EDIT", one can enter the program-
ming mode for BID-Chip/Key.
Highlight the "START & EDIT" line and confirm with
"ENTER" button, the screen changes to show the BID-Chip
Key programming menu. The illustration shown alongside
will be divided into three sections. The arrow shows the
line to change the parameter. Via the last line "END", one
returns to the screen showing the stored battery informa-
tion.
24