Setting The Temperature; Switching Off; Automatic Switch-Off Time; Cleaning And Maintenance - Beurer HK 47 To Go Gebrauchsanweisung

WARNING
If the heating pad is being used over several hours, we recommend
that you set the lowest temperature setting on the controller to avoid
overheating the heated body part, which may lead to burns to the skin.
NOTE
When the powerbank (1) has been almost completely run down, the heating pad is switched off
automatically to protect the powerbank. The powerbank must then be charged.

4.6 Setting the temperature

OFF: On/Off button (3) not lit
Setting 1: Minimum heat (LED display of the On/Off button lights up green)
Setting 2: Medium heat (LED display of the On/Off button lights up yellow)
Setting 3: Maximum heat (LED display of the On/Off button lights up red)

4.7 Switching off

Press the On/Off button (3) to switch off the heating pad (2). The switching sequence is 1 ­ 2 ­ 3 ­ OFF ...
The LED display of the On/Off button and the LED display on the powerbank (1) go out when the heating
pad is switched off.
NOTE
Please note that the powerbank (1) must be protected against extreme cold (placed under clothing
where appropriate) to maintain its full performance.

4.8 Automatic switch-off time

This heating pad (2) is equipped with an automatic switch­off function. This turns off the heat supply approx.
110 minutes after the initial use. The On/Off button on the heating pad (3) and the blue LED display on the
powerbank go out.
You can switch the heating pad on again immediately by pressing the On/Off button on the heating pad. If it
is no longer possible to switch the heating pad on, then the powerbank has been run down.

5. Cleaning and maintenance

IMPORTANT
• Before cleaning, always first disconnect the powerbank (1) from the heating pad (2). Remove the
powerbank from the heating pad's pocket. otherwise there is a risk of damage.
IMPORTANT
• The powerbank (1) must never come into contact with water or other liquids as this may cause
damage.
To clean the powerbank (1), use a dry, lint­free cloth. Do not use any chemical or abrasive cleaning agents.
IMPORTANT
• Please note that the heating pad (2) may not be chemically cleaned, wrung out, tumble dried, put
through a mangle or ironed. Otherwise the heating pad may be damaged.
This heating pad is machine­washable. For this purpose, close the hook­and­loop fastener of the heating pad
and place it in a pillow case. Set the washing machine to a particularly gentle wash cycle at 30 °C (wool cycle).
For ecological reasons, always wash the heating pad (2) together with other textiles.
15