Charging The Powerbank; Charging A Smartphone Via Powerbank; Operating The Heating Pad; Switching On - Beurer HK 47 To Go Gebrauchsanweisung

4.2 Charging the powerbank

IMPORTANT
Before you begin charging the powerbank (1), please note the information in section 2 "Important
information".
The powerbank must be charged fully prior to initial use or if the device has not been used for a long
period. If the powerbank is completely run down, the charging process will take approx. 6 hours until
it is fully charged again. To charge the powerbank fully, proceed as follows:
– Insert the charging cable (5) provided into the connection socket of the powerbank.
– Connect the other end of the charging cable to a USB charger via the USB port (USB charger with 5V / 1A
SELV in accordance with the requirements of IEC/EN 60335, not included). Whilst charging, the LED display
on the powerbank flashes green.
– As soon as the LED display on the powerbank lights up permanently green, the powerbank is fully charged
(after approx. 6 hours from empty). Then disconnect the powerbank from the charger.
– The green LED display on the powerbank goes out once the powerbank has been disconnected from the
USB charger.
– The powerbank should be charged at least once a year to retain its capacity.
– Do not cover the powerbank with covers, cushions or similar during the charging process in order to
prevent overheating.
– Only charge the powerbank in a dry environment and at normal room temperature.

4.3 Charging a smartphone via powerbank

The powerbank can be used for more than just operating the
heating pad – it can also be used to charge the battery of a
smartphone. To charge your smartphone using the power­
bank, proceed as follows:
• Connect the powerbank to your smartphone using the
original USB charging cable from your smartphone manu­
facturer.

4.4 Operating the heating pad

• Place the charged powerbank (1) into the integrated pocket on the heating pad (2).
• Then insert the connector plug for the connection cable (4) of the heating pad into the connection socket
on the powerbank. The LED display of the On/Off button (3) on the heating pad briefly lights up white twice.
The heating pad is now ready for use.
IMPORTANT
Ensure that the heating pad will not bunch up or become folded during use.

4.5 Switching on

• Press the On/Off button (3) to switch on the heating pad (2). The LED display of the On/Off button lights
up green (minimum heat). The LED display on the powerbank (1) lights up blue.
• If you press the On/Off button again, the temperature setting will increase (medium heat). The LED display
of the On/Off button lights up yellow.
• If you press the On/Off button again, the heating pad switches to the maximum temperature setting (maxi­
mum heat). The LED display of the On/Off button lights up red.
• If you press the On/Off button again, the heating pad switches off. The LED display of the On/Off button
and the LED indicator on the powerbank go out.
14