Waeco mobitronic MBC-2000A/S Bedienungsanleitung Seite 25

MBC-2000.book Seite 25 Mittwoch, 30. Juni 2004 5:19 17
battery charger
✓ The green LED illuminates when the charging procedure is completed
and the battery is recharged (Fig. 8 F, Page 3).
The device switches to idle mode.
Unclamping the battery charger
Caution!
When unclamping the battery charger, make sure not to cause a
short-circuit.
➤ When the charging procedure is finished, pull the 230-V mains plug from
the socket.
➤ Unclamp the black minus clamp of the battery charger.
➤ Unclamp the red plus clamp of the battery charger.
Warning!
Make sure to avoid contact with the battery fluid!
➤ Check the fluid level of the battery cells.
If the fluid is below the minimum level in one or more cells, add distilled
water until the fill mark is reached.
Never use normal tap water.
➤ Close any opened sealing caps of the battery cells.
➤ Re-clamp the battery to the vehicle system.
➤ Lubricate the battery poles with a bit of terminal grease to protect them
against corrosion.
5.2 Providing jump starts
Connect the battery as follows:
➤ Make sure that the device is not connected to the 230-V mains connec-
tion.
➤ Set the B switch (Fig. 8, page 3) to "Start".
➤ Connect the red plus clamp of the battery charger to the positive pole (+)
of the battery (see Fig. 6, page 2).
Using the battery charger
25