Installation; Electrical Connection - Zanussi ZBA22442SA Benutzerinformation

Problem
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.
Closing the door
1. Clean the door gaskets.

Installation

WARNING!
Refer to Safety chapters.
Location
Refer to the assembly instructions
for the installation.
To ensure best performance, install the
appliance well away from sources of heat such
as radiators, boilers, direct sunlight etc. Make
sure that air can circulate freely around the back
of the cabinet.
Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate class
indicated on the rating plate of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
www.zanussi.com
Possible cause
The food products' temperature
is too high.
Many food products are stored at
the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened often. Open the door only if necessary.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective door
Climate
T

Electrical connection

• Before plugging in, ensure that the voltage
• The appliance must be earthed. The power
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Store less food products at the
same time.
Defrost the appliance.
"Installation".
gaskets. Contact the Authorised Service
Centre.
Ambient temperature
class
+16°C to + 43°C
Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation can
only be guaranteed within the
specified temperature range. If you
have any doubts regarding where to
install the appliance, please turn to
the vendor, to our customer service
or to the nearest Authorised Service
Centre.
and frequency shown on the rating plate
correspond to your domestic power supply.
supply cable plug is provided with a contact
for this purpose. If the domestic power
supply socket is not earthed, connect the
appliance to a separate earth in compliance
with current regulations, consulting a
qualified electrician.
Solution
21