Installation - Zanussi ZRB34103XA Benutzerinformation

If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
Replacing the lamp
The appliance is equipped with a
longlife LED interior light.
CAUTION!
Disconnect the plug from the mains
socket.
Installation
WARNING!
Refer to Safety chapters.
Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate class
indicated on the rating plate of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation can
only be guaranteed within the
specified temperature range. If you
have any doubts regarding where to
install the appliance, please turn to
the vendor, to our customer service
or to the nearest Service Centre
www.zanussi.com
All manuals and user guides at all-guides.com
1. At the same time, with the fingers expand
2. Replace the lamp with one of the same
3. Reassemble the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
Electrical connection
• Before plugging in, ensure that the voltage
• The appliance must be earthed. The power
• The manufacturer declines all responsibility if
• This appliance complies with the E.E.C.
up and down the transparent cover and
unhook it in the direction of the arrows.
1
2
1
power and shape, specifically designed for
household appliances. (the maximum power
is shown on the light bulb cover).
Make sure that the light comes on.
and frequency shown on the rating plate
correspond to your domestic power supply.
supply cable plug is provided with a contact
for this purpose. If the domestic power
supply socket is not earthed, connect the
appliance to a separate earth in compliance
with current regulations, consulting a
qualified electrician.
the above safety precautions are not
observed.
Directives.
25