Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Rotor
• Damaged rotor blades must be exchanged! Refrain from attempts
at repair!
• Keep away from the rotors, as soon as the battery is connected.
• Avoid presence in the plane of rotation of the rotors.
GB

Battery charger

Employ exclusively the enclosed battery
charger.
• Operate the battery charger only on fire resistant surfaces and
• Also place the battery on a non-inflammable surface while charging.
• Ensure for sufficient ventilation of the battery charger while
charging.
Never subject the battery charger, the batteries
and the model to adverse local conditions!
These are for instance:
• Wetness, too high air humidity (> 75% rel., condensing). Do not
touch the battery charger with wet hands.
• Never operate the battery charger right after it has been brought
from cold into warm surroundings. The resulting condensation
water can destroy the device. Permit the device to attain the
ambient temperature while unconnected.
• Dust and inflammable gases, vapours or solvents, benzene
• Too high ambient temperatures (> about +40°C), direct solar
radiation
• Open fire, ignition sources
• Mechanical stresses such as shocks, vibrations
• Strong contamination
• Strong electromagnetic fields (motors or transformers) or
electrostatic fields (charges)
• Transmitters (radio telephones, transmitters for model building
etc.). The transmitter radiation can lead to the malfunction of the
charging operation or to the destruction of the battery charger and
thereby also of the batteries.
24
CARSON Mini Tyrann
Do not operate the model while seated, so that you can rapidly get out
of the hazardous area if necessary.
Tighten the retaining bolts of the rotor blades only so much that in
flight these can orient themselves by 180° to each other only with
centrifugal force.
• Never leave the battery charger unattended during the charging
process.
• Never mix fully charged batteries and batteries which have already
run low, or batteries of a different capacity at the same time.
• When charging the batteries pay attention to the correct polarity.
Permit the battery charger to cool down
between charging operations. Disconnect the
battery charger from the power when the c
harging operation is finished.
A defective battery charger may no longer be employed.
If it is assumed that the device is defective, i.e. if
• The device shows visible damage,
• The device no longer works and
• After longer storage under unfavourable conditions or
• After severe transportation stress, then it should be made
inoperative without delay and secured against unintentional
operation.
Dispose of the unusable (irreparable) battery charger according to the
prevailing statutory regulations.
For safety and registration reasons (CE), the arbitrary reconstruction
and/or modification of the battery charger is not permitted.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis