Transport; Storage; Maintenance And Care; Frost Protection - Kärcher BR 4.300 Originalbetriebsanleitung

Transport

Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
Swivel the appliance handle forward
and arrest in the park position.
Swivel the pushing handle backwards
and push the appliance.
or
Lift appliance by the carrying handle
and carry it.
When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

Maintenance and care

Danger
Risk of injury by inadvertent startup of ap-
pliance and electrical shock.
First pull out the plug from the mains before
carrying out any tasks on the machine.
Caution
Risk of damage to the appliance on ac-
count of water leakage. Empty the waste
water reservoir and the fresh water reser-
voir prior to performing maintenance on the
appliance.
Maintenance schedule
After the work
Caution
Risk of damage. Do not wash down the ap-
pliance with water and do not use aggres-
sive detergents.
Empty the dirt water reservoir.
Clean the seals between the waste wa-
ter reservoir and the appliance.
14

Storage

Empty the fresh water reservoir.
Rinse the appliance: Fill the fresh water
reservoir with clear water (without de-
tergent) and let the appliance run for
one minute with the brush water supply
turned on.
Empty the fresh water reservoir.
Clean the outside of the appliance with
a damp cloth which has been soaked in
mild detergent.
Clean the vacuum bar, check for wear
and replace if required (see "Mainte-
nance tasks").
Check the brush for wear and replace if
required (see "Maintenance tasks").
Maintenance Works
Replace the vacuum bar.
Note
The vacuum bars are attached to the appli-
ance with snaps and can simply be pulled
off.
Remove the fresh water reservoir.
Remove the dirt water reservoir.
Lay the device on the reverse.
Pull off the vacuum bar downwards.
Insert the new vacuum bars and lock
them into place.
Replacing the brush roller
Remove the fresh water reservoir.
Remove the dirt water reservoir.
Lay the device on the reverse.
Press the release button for the brush
roller and swivel the brush roller toward
the bottom and pull it off the driver.
Place the new brush roller on the driver
and lock into place on the opposite side.

Frost protection

In case of danger of frost:
Empty the fresh and dirt water reser-
voirs.
Store the appliance in a frost-protected
room.
– 4
EN