Safety Advice Relating Specifically To Electric Nailer / Staplers; Before Use; Loading The Magazine; Setting The Impact Force - Parkside PET 25 B1 Bedienungs- Und Sicherheitshinweise

If the tool is not in contact with the workpiece, the
fastener may be deflected away from your target.
Disconnect the tool from the power
source when the fastener jams in the
tool. While removing a jammed fastener, the
tacker may be accidentally activated if it is
plugged in.
Use caution while removing a jammed
fastener. The mechanism may be under com-
pression and the fastener may be forcefully
discharged while attempting to free a jammed
condition.
Do not use this tacker for fastening elec-
trical cables. It is not designed for electric ca-
ble installation and may damage the insulation
of electric cables thereby causing electric shock
or fire hazards.
Safety advice relating specifi-
Q
cally to Electric nailer / staplers
D ANGER OF INJURY! Never point the de-
vice at yourself or at other people or animals.
Ensure that no people or animals are on the
other side of the workpiece.
P ROTECT YOUR EYES! Wear eye protection
or goggles. This also applies to people who
may be helping with the work by supporting or
holding the workpiece.
M ake sure the device is switched off before
you load the magazine. Set the ON / OFF
switch to position "0" and pull the mains plug
out of the mains socket!
D o not use the device to fix electrical cabling
in place.
S ecure the workpiece. A workpiece held in a
clamp or vice is kept more securely in place
than one held by your hand.
A lways work with the mains lead leading away
from the rear of the device.
D ANGER OF INJURY! Use the device with
only the staples and nails specified above.
Ensure that the staples or nails do not project
from the surface of the workpiece or penetrate
through to the other side.
S hort-term operation time: Let the device cool
down after 15 minutes of continuous operation.
Safety instructions for tackers / Before use
D ANGER OF INJURY! Keep your fingers and
other body parts away from the front plate
N ever fire staples or nails through the air. At
short range the shot staples or nails could lead
to serious injury.
O nly soft materials such as wood or textiles
should be joined using the device. Otherwise
the device could be damaged.
CAUTION! Connect the device to the mains
only when it is switched off. Set the ON / OFF
switch to position "0".
3
Switch the device on just before you intend to
use it. If you are not using the device, switch it
off to prevent unintentional firing.

Before use

Q

Loading the magazine

Q
S queeze the end of the magazine slider
(see Fig. A).
P ull the magazine slider
(see Fig. B).
5
F ill the magazine
(see Fig. C).
Note on filling with nails: Use the right-
hand slot for filling with nails as shown in the
detailed image in Fig. C. Ensure that the nail
heads are all at the top.
NOTE: Observe the maximum capacity of ap-
prox. 85 staples or approx. 75 nails when filling.
A fter filling, push the magazine slider
the magazine
5
hear and feel it engage.
NOTE: The magazine filling level indicator
allows you to see whether there are still staples
in the magazine.

Setting the impact force

Q
NOTE: Select the lowest impact force necessary
for your stapling.
Take into account the length of the staples or nails
to be used and the strength of the materials to be
joined.
DANGER OF INJURY!
out of the magazine
4
with staples or nails
5
as far as it will go until you
GB/IE
.
7
4
into
4
6
9