Cold Start; Stopping The Motor; Warm Start; Throttle Trigger - Ikra BHSN 602 Gebrauchsanweisung

2. Ensure you have a firm footing.
3. Lay the hedge trimmer on the ground in front of you,
with the cutter facing away from you.
4. Place the end of your right foot into the rear hand grip.
5. Hold the front hand grip with your left hand.

Cold start

21
23
1. Slide the ON/OFF switch (3) into the position
2. Press carefully on the primer pump (23) several
times until fuel reaches the pump.
3. Move the start lever (choke) (21) to
4. Slowly pull out the start cord on the starter handle
(11) until there is resistance.
5. Pull quickly on the starter handle, then slowly release
it.
Do not pull the start cord all the way out, and do not
let the starter handle snap back against the motor.
6. Move the start lever (choke) (21) to
the motor has started up, or after pulling it no more
than 5–6 times.
7. The motor idles.
8. Allow the tool to idle for about a minute before start-
ing work.

Stopping the motor

1. Release the throttle trigger (6).
2. Set the ON/OFF switch (3) to the position

Warm start

1. Move the ON/OFF switch (3) into the position
2. Move the start lever (choke) (21) to
cord on the starter handle (11) until the motor starts
up.
GB | Operating instructions
3
11
6
1
, as soon as
21
0
.
1
.
. Pull the start

Throttle trigger

4
1. Hold the hedge trimmer by the rear hand grip (4) and
push the throttle trigger lock (1); this releases the
throttle trigger (6).
2. Hold the front hand grip (13) with your other hand.
3. Press the throttle trigger (6).
4. The cutter starts up.
If the throttle trigger (6) is released, the cutter stops
and motor idles.
If the cutter runs despite the throttle trigger not be-
ing pressed, the idling speed must be reduced (see
„Maintenance").

Settings on the hedge trimmer

Adjusting the rear hand grip (4)

4
To help you to guide the hedge trimmer, the rear hand
grip can be set in one of three working positions.
The rear hand grip may only be adjusted when the cutter
is stopped.
The throttle trigger (6) cannot be operated if adjust-
ment is in progress.
1. Hold the hedge trimmer firmly by the front hand grip
(13) with your left hand.
2. Slide the lock (5) down.
3. Rotate the hand grip to the desired position.
4. Release the hand grip lock (5). Make sure that the
lock engages again and that the hand grip is securely
fixed in place.
8
1
6
5
0°
6
90°
90°