L. G. B. WP&Y 108 Bedienungsanleitung Seite 14

suit your requirements. If you
want to do this, program the
"function values" in "registers"
(CVs) using a PC and the 55045
MTS PC Decoder Programming
Module. You can also program the
function values using a 55015
Universal Remote.
Hints:
- For normal operation, it is not
necessary to change the func-
tion values.
- If programming results in unsat-
isfactory operation, you can
reprogram the factory pre-set
values of most important CVs:
Program register CV55 to func-
tion value 55. This also repro-
grams the loco address to the
factory pre-set value.
To reprogram the factory pre-set
function values with the 55015
(displays shows "P --") input 6, 5,
and 5 and press the right arrow
button. The display shows "P --"
again: Input 5, 5, and 5 and press
the right arrow button again.
You can program the following
registers:
14