Installation In Windows Nt - Siemens 6GK1141- 1AA00 Installationsanleitung

Installation Instructions CP 1411
3.3

Installation in Windows NT

Requirement 1
Requirement 2
Driver Installation
36
The CP 1411 communications processor must already be installed in
the PC/programming device.
The Plug and Play mechanism in your PC/programming device
must be deactivated!
Check that this is the case on your PC/programming device. This
mechanism is normally enabled/disabled in the BIOS.
Note:
Under Windows NT, the plug and play mechanism must be activated
("PnP Configuration").
When shipped, the plug and play mechanism of the CP 1411 is en-
abled! (You can enable and disable the Plug and Play mechanism of
the module with AMINSTAL).
Before you can operate the CP 1411 communications processor under
Windows NT, the driver must first be installed in Windows NT.
Under no circumstances should you use the driver included in
Windows NT, but only the driver from the installation diskette
from Siemens!
Section continued on the following page
Installationsanleitung CP 1411
C79000-Z8974-C24-05