Changing The Select Keys - G&D TradeSwitch4-USB Installation Und Bedienung

Configuration

Changing the select keys

In the default settings, use the enabled select keys
puters that are connected to the KVM switch.
For instance, you can switch to computer 2 by pressing
How to choose a different select key set:
1. Press Hotkey+Backspace
mode.
If the hotkey delay is active, press the key combination for seven seconds.
2. Press one of the setup keys shown below to activate the desired set of select
keys to switch the computers 1 to 4:
 Enables select keys 1, 2, 3, 4
1
 Enables select keys NUM 1, [...], NUM 3, NUM 4
NUM 1
Z  Enables select keys A, B, C, D
F1  Enables select keys F1, F2, F3, F4
1. Use the terminal emulator to establish a connection to the KVM switch.
2. Use the Arrow
3. Press the
Space
switch the computers 1 to 4:
1 ... 4
NUM 1 ... 4
A ... D
F1 ... F4
4. Press the
S
21 · G&D TradeSwitch4-USB
(default:
or Arrow keys to select the
key (repeatedly) to enable the particular set of select keys to
 Enables select keys 1, 2, 3, 4
 Enables select keys NUM 1, [...], NUM 3, NUM 4
 Enables select keys A, B, C, D
 Enables select keys F1, F2, F3, F4
key to save your settings.
1 to 4 to switch between the com-
Hotkey+2
Alt Gr+Backspace ) to enable the setup
Select Key
(default: Alt Gr+2
row.
).