Changing The Double Hotkey - G&D TradeSwitch4-USB Installation Und Bedienung

Changing the double hotkey

If the use of double hotkeys is enabled (see page 18), press the double hotkey and the
Backspace key simultaneously to start the setup mode of the KVM switch. Switching
of channels takes place by pressing the double hotkey and a select key at the same
time.
If an application program or another G&D device uses the same hotkey within the
cascade, the hotkey can be changed.
How to change the current double hotkey:
1. Requirement: enabled double hotkeys (see page 18).
2. Press Double hotkey+Backspace
setup mode.
If the hotkey delay is active, press the key combination for seven seconds.
3. Press one of the setup keys listed below to activate the desired double hotkey:
 Enables Alt Gr+Ctrl double hotkey
Alt Gr
Win  Enables Win+Ctrl double hotkey
 Enables Shift+Win double hotkey
Shift
 Enables Ctrl+Shift double hotkey
Ctrl
Alt  Enables Alt+Shift double hotkey
1. Requirement: active double hotkeys (see page 18).
2. Use the terminal emulator to establish a connection to the KVM switch.
3. Use the Arrow
4. Press the Space
 Enables Alt Gr+Ctrl double hotkey
Alt Gr+Ctrl
Win+Ctrl  Enables Win+Ctrl double hotkey
 Enables Shift+Win double hotkey
Shift+Win
Ctrl+Shift  Enables Ctrl+Shift double hotkey
 Enables Alt+Shift double hotkey
Alt+Shift
5. Press the S key to save your settings.
(default:
or Arrow keys to select the
key (repeatedly) to enable the desired double hotkey:
Alt Gr+Ctrl+Backspace
Hotkey row.
G&D TradeSwitch4-USB · 20
Configuration
) to enable the