Appliance Description; Hand Switch - Beurer MG 190 Gebrauchsanleitung

4. Appliance description

Shiatsu massage pillow (front)
1
2
3
3
5 4
6

hand switch

5. Start-up
CAUTION
• IMPORTANT: Deactivate the transport lock on the massagemechanism before starting-up for
the first time. Remove the screw on the reverse side of the seat cover using the tool supplied.
The Shiatsu seat cover will be irreparably damaged and unusable if the transport lock screw
is not removed and the Shiatsu seat cover is operated immediately. No guarantee is accepted
in this case.
• Insert the transport fixation screw each time the device is transported again. The device
may be irreparably damaged each time it is transported without the transport lock.
• Remove all other packaging and transport locks. Ensure that the packaging foils do not fall into children's
hands. Risk of suffocation.
• Check the device, power supply unit and all cables for damage.
• Secure the protective cover on the surface of the Shiatsu seat cover using the Velcro strips where the seat
joins with the backrest, on the reverse side at the front under the seat surface and at the top in the shoulder
area. It is also possible to massage without the protective cover; this is generally found to be "harder".
• Position the seat cover upright on a suitable seating arrangement with seating surface and backrest
(chair, sofa, or similar). Ensure that the seat cover is supported over its entire area and has a sufficiently
high backrest. As a result of the solid back cover, the Shiatsu seat cover can also be operated with small
backrests.
• Use the flexible fastening straps and Velcro strips to secure the Shiatsu seat cover.
• Connect the power supply unit and the seat cover with the plug connector.
7
1
2
3
1 Protective cover
2 Four massage heads, rotating in pairs with
vertical movement
3
3 Fastening straps
4 Connecting coupling
5 Power supply unit with plug connector and power
3
cable
6 Hand switch
7 Storage bag
1 ON/OFF button with control LED
2 MASSAGE button with control LEDs
3 TIMER button with control LEDs
4 Connection cable to the device
4
12