Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Visor
Your helmet has an insert
pocket on both the right
and left which you can
use to click in the holder
for the visor A.
To fit the visor, push its
holder clip B into the
snap-in fitting of the
holder A until it snaps into
place.
As visors only provide limited protection against flying particles, their level of
safety for the eyes is only secondary.
Always wear protective goggles when working with chain saws or devices used
for cutting and prising open etc.
Visors are not suitable for use at high ambient temperatures.
The visor should be removed for structural fire fighting.
The performance of your visor has been tested under the temperature range
-40°C to 120°C.
Components not being marked "T" should not be used under extreme temperature.
Mesh visors are not suitable to protect against heat, flames, sparks, hazardous
liquids, molten material or electricity.
Damaged visors must be replaced.
Marking of the visor
Marking
EN14458:2004
Bullard
A/B 10cm / 15cm
R330
10
. +
Optional characteristics and marking
.-40°C
K
N
Contact with liquid chemicals
The durability of the visor and adapters was tested with the following
chemicals
Chemical
Sulfur dioxide
sodium hydroxide
p-Xylene
butane- 1 -oL
n-Heptane
6
B
A
WARNING
Explanation of marking
European standard upon which
marking is based
manufacturer
Visor type and size
example for item number
example for year of manufacturing
suitable for fire fighting
rating as face protection
suitable down to -40°C
abrasion resistance
anti-fog
Concentration
30%
10%
undiluted
undiluted
undiluted
www.bullardextrem.com
Diagram transmission factor
The radiant heat protection provided by this visor varies with the temperature of the
heat source as shown in this graph. The visor should only be used in situations where it
can reduce the exposure of the wearer's eyes
to below 100 W/m².
Ear Neck Protectors
All available variants are fitted with Velcro fastening. Adjust the headband to the
smallest size for assembly. Fold the nape protection at the middle and start to fasten in
the nape protection to the right and left at the rear of the helmet.
Ensure a flush fit.
For the assembly of a Dutch Ear Neck protector it is recommended to take out the head
ring first, assemble the Dutch Ear Neck Protector and reassemble the head ring.
Werbung
