Bullard H1500 Benutzerhinweise Seite 5

Thank you for choosing a fire service helmet from Bullard.
Protection helmets are an integral element of personal safety equipment and help
prevent, or at least reduce, head injuries.
Please spare some time to read the following information so you can properly adjust
your helmet. It has been written with both your safety and comfort in mind.
Head Size, size adjustment and weight
The helmet can be adjusted infinitely to any head size from 52 –64 cm.
Total weight with no accessories is approx. 950g.
First adjust the size range on the headband.
H1500 model with SURE LOCK® ratchet system
Open the wheel ratchet counterclockwise.
Put on your helmet and turn the wheel ratchet clockwise until it rests firmly yet
comfortably on your head.
Adjusting the headband height
You DO NOT have to remove the suspension in order to vertically adjust the height.
The 4-pt. suspension has two vertical positions: high and low. A custom fit can be
accomplished by simply pulling the key peg out and inserting it into the desired slot
height position on the headband.
Key Pegs
USER INSTRUCTIONS for the Fire Service
Chin strap
Open and close the chin strap with the Quick-Release Buckle. Adjust the length of the
chin strap with the sliders to the left and to the right. Shorten the strap by pulling the
loose ends of the straps. Push up the sliders to lengthen the strap. Adjust the neck
strap with the snap buckle. The helmet meets standard requirements on retention
system effectiveness and strength as long as the chin strap is adjusted as mentioned
above and 2 fingers in between chin strap and chin.
Vertical
Adjustment
Key Pegs
Adjustment Chin Strap
www.bullardextrem.com
Helmet H1500
Ratchet
Figure 1
Posts
Figure 3
Figure 5
Quick-Release Buckle
Headband Adaption
Figure 2
Adjustment
Neck Strap
Figure 4
Figure 6
5