Replacing The Fuse; Technical Specifications - EuroLite 51918630 Bedienungsanleitung

The lenses have to be replaced when they are obviously damaged,
so that their function is impaired, e. g. due to cracks or deep scratches!
The front mirrors and the objective lenses will require weekly cleaning as smoke-fluid tends to building up
residues, reducing the light-output very quickly.
The interior of the fixture should be cleaned at least annually using a vacuum-cleaner or an air-jet.
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
DMX control channels:
DMX512 connection:
Sound-control:
Flash-rate:
LED type:
Number of 5 mm LEDs:
Number of 9 mm LEDs:
Dimensions (LxWxH):
Weight:
Maximum ambient temperature T
Maximum housing temperature T
Min. distance from flammable surfaces:
Min. distance to lighted object:
Fuse:
Please note: Every information is subject to change without prior notice. 08.02.2012 ©
CAUTION!
230 V AC, 50 Hz ~
50 W/90 VA
2/10
3-pin XLR
via built-in microphone
10 Hz
5 mm LED/9 mm LED
132
48
500 x 500 x 255 mm
5 kg
: 45° C
a
(steady state): 55° C
C
0.5 m
0.1 m
F 1 A, 250 V
27/27 00065878, Version 1.0