Kemper KHS-Mini MASTER Einbau- Und Bedienungsanleitung Seite 77

The following configuration steps are discussed based on the sample project from
Illustration 8.1 (Page 16). For an overview of the system commissioning, Illustration 8.26
is presented.
Ill. 8.26 Overview for the system commissioning of the sample project
Configuration -MASTER- (C-valve)
In the sample project being used, the KHS Mini System Control -MASTER- should trigger
a C-valve in the form of a VAV-maximum flow isolating ball valve with spring reset servo-
drive. Furthermore, a KHS CONTROL-PLUS flow measurement valve is to be evaluated.
Additional settings for this operating mode are explained in Chapter 8.1.4.4. Illustration
8.27 shows the configuration of a C-valve.
Device selection
03
04
Ill. 8.27 Configuration of C-valve
Manual KHS Mini System Control MASTER
Control type
Valve
Select sensor
26
-
deactivated
C-valve
C-valve
safety/leak detection
safety/leak detection