Warranty; Introduction/Technical Data - ersa EASY ARM 1 Bedienungsanleitung

Introduction/Technical Data

1.2

Warranty

The filters represent wearing parts which are not subject to warranty. Material or manufac-
turing defects must be indicated and accompanied by the return of goods, giving notice of the
defect as well as producing the purchase receipt, which must be confirmed, before returning
the goods.
The warranty time complies with the specifications of the applicable General Conditions
of Sale, Delivery and Payment of Ersa GmbH. Ersa GmbH can only assume a warranty if the
device is returned in the original packaging.
Any inappropriate use and tampering with the device shall void the warranty and liability
claims of the buyer against the manufacturer.
2. Technical data
EASY ARM 1
Dimensions (H x W x D)
Weight
Noise level
Volume flow rate per connection
Low pressure
Filter class:
Filtration efficiency (HEPA):
Pre-filter 1- 10 µm particles;
Combination filter < 1 µm particles
Combination filter area
Gas filter
Combination filter service life
Electrical data
Fuse
Connections
18
470 mm x 255 mm x 255 mm
7.5 kg
50 dB (A)
110 m³/h (free-range/with a new filter)
1800 Pa
F7 pre-filter (fleece)/H13 combination filter
80 – 90 %;
99.95 %
2.2 m²
Activated carbon
1,500 h (in single-shift operation, hand soldering)
50 W, 100-240 V AC, 50/ 60 Hz
6.3 A
Interface to i-CON soldering stations or remote switch
Note on the filtering action:
Optimum gas filtering requires the following parameters:
Temperature of the process air in the gas filter: < 38 °C
Relative humidity: < 60 % RH
Boiling point of the substance: > 0 °C
3BA00216 • 2014-07-25 • Rev. 1
ersa EASY ARM 1