Power On/Off - LD Systems MAUI 28 G2 Bedienungsanleitung

15
BLUETOOTH
®
The mixer of the LDMAUI28G2 array system is equipped with Bluetooth, meaning that audio files from another Bluetooth device (e.g. Smart-
phone) can be played back on the LDMAUI28G2 array system (maximum distance between both devices about 10 metres). If no Bluetooth
device is connected to the internal Bluetooth unit, the blue Bluetooth LED does not light up; the LED flashes at a frequency of about 3 Hz
during pairing; if the Bluetooth LED is on permanently, then a Bluetooth connection is established and the track playback can be started. The
volume is adjusted using the Bluetooth
To pair and connect the internal Bluetooth device with a Bluetooth-enabled device, press and hold the HOLD TO LINK button for approx. 3
seconds until the Bluetooth LED flashes (approx. 3 Hz), enable Bluetooth on your Bluetooth device and search for available devices on the user
interface. Select "LD MAUI28G2" and pair your Bluetooth device with the internal Bluetooth device. The playback can now start. To end the
connection, press and hold the HOLD TO LINK button again for approx. 3 seconds. If the Bluetooth connection is interrupted (e.g. the range is
exceed), the Bluetooth LED goes out. Within approximately 90 seconds, the connection will automatically be restored (Bluetooth device back
within range). When 90 seconds is exceeded, the Bluetooth module of the LD MAUI28G2 array system will automatically be disabled.
16
MP3/BLUETOOTH LEVEL
Volume controller for the MP3 channel and the Bluetooth unit. When turned to the left, the volume is lowered, when turned to the right,
it is increased.
17
SYSTEM OUT
Balanced line output with 3-pin male XLR socket.
If the Mono mode is activated (point 5 MONO / STEREO), the sum of all input channels will be rendered in Mono.
Select the Mono mode and use the SYSTEM OUT line output to control another MAUI28G2 Mono unit.
If the Stereo mode is enabled (point 5 MONO / STEREO), the left channel of all stereo inputs (N 9, 10, 14 and 15) is processed internally
and rendered by the MAUI28G2 array system, while the right channel of all stereo inputs is rendered by the SYSTEM OUT line output to
control another MAUI28G2 unit externally as a stereo expansion. The sum of the Mono channels MIC IN and HI-Z IN is output in equal parts
internally on the left and externally on the right.
Note: To achieve the same volume as well as the same sound as the main unit with the stereo expansion, turn the volume controller of the
stereo expansion LINE LEVEL clockwise (maximum) and place the SUB LEVEL and MAIN LEVEL in the same position as the SUB LEVEL and
MAIN LEVEL of the main unit.
18
SUB OUT
Balanced line input with male 3-pin XLR socket for connecting an external active subwoofer. The signal is now picked up after the SUB
LEVEL volume controller; it is therefore dependent on the latter.
19
POWER CONNECTOR WITH FUSE HOLDER
IEC power socket with built-in fuse holder. An appropriate power cord is included in the delivery.
IMPORTANT INFORMATION: Replace the fuse only with a fuse of the same type and rating. Please observe the label on the housing. If the
fuse blows repeatedly, please contact an authorised service centre.
20
POWER ON / OFF
On / Off switch for the power supply of the device.
8
volume controller (N 16) or on the source device.
®
20
19