Basic Operation - Kenwood NX-5800E Anleitung

SWITCHING POWER ON/ OFF
Press [ ] to switch the transceiver ON.
Press [ ] again to switch the transceiver OFF.
ADJUSTING THE VOLUME
Press the key programmed as [Volume Up] to increase the volume. Press the key programmed as [Volume Down] to
decrease the volume.
SELECTING THE ZONE AND CHANNEL
Select the desired zone and channel using the keys programmed as [Zone Up]/ [Zone Down] and [Channel Up]/
[Channel Down].
TRANSMITTING
1 Select the desired zone and channel.
2 Press the key programmed as [Monitor] or [Squelch Off] to check whether or not the channel is free.
• If the channel is busy, wait until it becomes free.
3 Press the PTT switch and speak into the microphone. Release the PTT switch to receive.
• For best sound quality at the receiving station, hold the microphone approximately 3 cm to 4 cm (1.5 inches) from your mouth.
RECEIVING
Select the desired zone and channel. If signaling has been programmed on the selected channel, you will hear a call only if
the received signal matches your transceiver settings.

BASIC OPERATION

2 < MO_BASIC_OP_PMR >