Kenwood DPX-7000DAB Bedienungsanleitung Seite 9

GETTING STARTED
TUNER SETTING
1
DAB L-BAND* ON: Receives L-BAND ensemble during digital audio reception. ;
OFF: Cancels
DAB ANT ON: Supplies power to the DAB antenna. Selects when using the supplied
1
POWER* antenna. ; OFF: Does not supply power. Selects when using passive
antenna without booster. ( 32)
PRESET TYPE NORMAL: Memorizes one station for each preset button in each band
(FM1/ FM2/ FM3/ MW/ LW/ DB1/ DB2/ DB3). ; MIX: Memorizes one
station (digital radio or analog radio) for each preset button, regardless
of the selected band.
DISPLAY
EASY MENU When entering [FUNCTION]...
ON: ZONE1 and ZONE2 illuminations change to white color. ; OFF: ZONE2
illumination changes to white color while ZONE1 illumination remains as
[COLOR SELECT] color. ( 21)
(Refer to the illustration on page 21 for zone identification.)
SYSTEM
2
KEY BEEP* ON: Activates the keypress tone. ; OFF: Deactivates.
SOURCE SELECT
BUILT-IN AUX ON: Enables AUX in source selection. ; OFF: Disables. ( 10)
P-OFF WAIT Applicable only when the demonstration mode is turned off.
Sets the duration when the unit will automatically turn off (while in
standby mode) to save the battery.
20M: 20 minutes ; 40M: 40 minutes ; 60M: 60 minutes ; – – –: Cancels
CD READ 1: Automatically distinguishes between audio file disc and music CD. ;
2: Forces to play as a music CD. No sound can be heard if an audio file disc
is played.
* 1
For .
* 2
Not applicable if 3-way crossover is selected.
Default: XX
F/W UPDATE
UPDATE SYSTEM/ UPDATE DAB1/ UPDATE DAB2
F/W UP xx.xx/
F/W UP xxxxx/
F/W UP Vxxx
FACTORY RESET
CLOCK
CLOCK DISPLAY
ENGLISH
РУССКИЙ
ESPANOL
Change the crossover type
1
Press
2
Press and hold number buttons 4 and 5 to enter crossover select.
The current crossover type appears.
3
Turn the volume knob to select "2WAY" or "3WAY", then press the
knob.
4 Turn the volume knob to select "YES" or "NO", then press the knob.
The selected crossover type appears.
• To cancel, press and hold
• To adjust the selected crossover settings, ( 20).
Caution
Select a crossover type according to how the speakers are connected.
( 31)
If you select a wrong type:
• The speakers may damage.
• The output sound level may be extremely high or low.
YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not
activated).
For details on how to update the firmware, see:
www.kenwood.com/cs/ce/
YES: Resets the settings to default (except the stored station). ;
NO: Cancels.
ON: The clock time is shown on the display even when the unit is
turned off. ; OFF: Cancels.
Select the display language for [FUNCTION] menu and music
information if applicable.
By default, [ENGLISH] is selected.
repeatedly to enter STANDBY.
.
5
ENGLISH