English - Kenwood AX950 Anleitung

Before reading, please unfold front page showing the illustrations
before using your Kenwood
attachment
Read these instructions carefully and
●
retain for future reference.
Remove all packaging and any
●
labels.
safety
Always ensure bones and rind etc
●
are removed from the meat before
mincing.
When mincing nuts only feed a few
●
down at a time and allow the scroll
to pick them up before adding any
more.
Switch off and unplug:
●
before fitting or removing parts
● ●
after use
● ●
before cleaning.
● ●
Always use the pusher supplied.
●
Never put your fingers or utensils in
the feed tube.
Warning - the cutting blade is sharp,
●
handle with care both in use and
when cleaning.
Ensure the attachment is secured in
●
position before switching on.
Never leave the machine on
●
unattended.
To avoid electric shocks, never let
●
the power unit, cord or plug get wet.
Never use a damaged machine. Get
●
it checked or repaired: see 'Service'.
Never use an unauthorised
●
attachment.
Never let the cord hang down where
●
a child could grab it.
This appliance is not intended for
●
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
Children should be supervised to
●
ensure that they do not play with the
appliance.

English

Only use the appliance for its
●
intended domestic use. Kenwood
will not accept any liability if the
appliance is subject to improper use,
or failure to comply with these
instructions.
before using for the first time
Wash the parts see 'care and
●
cleaning'
mincer
pusher lid
pusher
tray/storage box cover
mincer body
scroll
cutter
mincer screens: fine, medium,
coarse
ring nut
spanner
storage box
to assemble
1 Fit the scroll inside the mincer body.
2 Fit the cutter – cutting side
outermost
properly – otherwise you could
damage your mincer.
3 Fit a mincer screen
over the pin.
Use the fine screen for raw meat;
●
fish; small nuts; or cooked meat for
shepherd's pie or meat loaves.
Use the medium and coarse screens
●
for raw meat; fish; nuts; vegetables;
hard cheese; or peel or dried fruit for
puddings and marmalade.
4 Fit and tighten the ring nut.
to use the mincer
1 Remove the outlet cover by pressing
its top then lifting off
2 With the mincer in the position
shown
Rotate the mincer so that the feed
tube is upright.
4
. Ensure it's seated
. Put the notch
.
, locate in the outlet.