Getting Started; Cancel The Demonstration; Set The Clock And Date; Set The Basic Settings - JVC KD-X342BT Bedienungsanleitung

GETTING STARTED

1

Cancel the demonstration

When you turn on the power for the first time (or [FACTORY RESET] is set to
[YES]), the display shows: "CANCEL DEMO" "PRESS" "VOLUME KNOB"
1
Press the volume knob.
[YES] is selected for the initial setup.
2
Press the volume knob again.
"DEMO OFF" appears.
2

Set the clock and date

1
Press and hold .
2
Turn the volume knob to select [CLOCK], then press the knob.
To adjust the clock
3
Turn the volume knob to select [CLOCK ADJUST], then press the knob.
4
Turn the volume knob to make the settings, then press the knob.
Hour Minute
5
Turn the volume knob to select [CLOCK FORMAT], then press the knob.
6
Turn the volume knob to select [12H] or [24H], then press the knob.
To set the date
7
Turn the volume knob to select [DATE SET], then press the knob.
8
Turn the volume knob to make the settings, then press the knob.
Day Month Year
9
Press to exit.
To return to the previous setting item, press
4
ENGLISH
1
2
3
4
To return to the previous setting item, press
SYSTEM
KEY BEEP
SOURCE SELECT
F/W UPDATE
FACTORY RESET YES: Resets the settings to default (except the stored station). ;
* Not displayed when the corresponding source is selected.
.
3

Set the basic settings

Press and hold .
Turn the volume knob to select an item (see the following table),
then press the knob.
2
Repeat step until the desired item is selected or activated.
Press to exit.
(Not applicable when 3-way crossover is selected.)
ON: Activates the keypress tone. ; OFF: Deactivates.
AM SRC *
ON: Enables AM in source selection. ; OFF: Disables. ( 5)
BUILT-IN AUX * ON: Enables AUX in source selection. ; OFF: Disables. ( 16)
UPDATE SYSTEM
F/W UP xxxx YES: Starts upgrading the firmware. ;
NO: Cancels (upgrading is not activated).
For details on how to update the firmware, see:
<http://www.jvc.net/cs/car/>.
NO: Cancels.
.
Default: XX