Operation; Specifications - JVC XS-SR2 Bedienungsanleitung

Operation

1
Turn on the computer.
For details, refer to the Instruction manual of the computer.
2
Press to turn on the power.
The standby lamp turns green.
3
Press INPUT DIGITAL, INPUT ANALOG or
INPUT USB AUDIO to select the source.
4
Start playing back the connected
equipment.
5
Press VOLUME +/– to adjust the volume.
CAUTION
Set the volume to the minimum level before starting playback. If
the volume is set to a high level, the sudden blast of sound may
damage your hearing and blow out the speakers.
2
3
When using an AC adaptor or a stereo mini plug cable
When you use an AC adaptor or a stereo mini plug cable (not
supplied), make sure that a core filter is attached to the DC cord
end/the stereo mini plug cable end to reduce interference.
If not, attach one of the supplied core filters (small) as shown in the
illustration.
Run the cable through the core filter, and wind the cable firmly,
twice for DC cord end, once for stereo mini plug cable end,
inside the cutout of the core filter.
Core filter (small)
DC cord
5 cm
Core filter (small)
Stereo mini plug
cable
5 cm
CAUTION
Do not damage the cord by applying excessive force when winding.
Enjoying Surround Mode
This System is equipped with Virtual Dolby Surround. In
Surround Mode, it creates a rich surround sound effect with
two speakers.
To activate Surround Mode, press SURROUND MODE 1/2.
Pressing the button beeps...
– Once when SURROUND MODE 1 is selected, or
–
Twice when SURROUND MODE 2 is selected.
• SURROUND MODE 1:
• SURROUND MODE 2:
– To cancel, press SURROUND OFF.
Turning off the operation sounds
Press and hold SURROUND OFF until the standby lamp flashes
twice. The operation sounds are turned off.
• To restore the sounds, press and hold the button until the
standby lamp flashes once.
Standby lamp

Specifications

Output power:
• USB connection: 1.5 W (0.75 W + 0.75 W) at 4 Ω (10% THD)
• AC adaptor connection: 5 W (2.5 W +2.5 W) at 4 Ω (10% THD)
Speaker Type:
Full-Range Bass-Reflex Type (Magnetically-Shielded Type)
Speaker:
Speaker Impedance:
Analog Input (ANALOG IN):
Digital Input (DIGITAL IN):
USB Input (USB IN):
Power Source:
Dimensions (W × H × D):
Mass:
Accessories
USB cable (× 1)
Core filter (small × 2/large × 2*)
* Refer to "How to attach the core filter to the USB cable" on
the attached information sheet.
Creates a surround sound effect.
Creates a richer surround sound
effect than SURROUND MODE 1.
5
SURROUND MODE buttons
4 cm cone × 2
125 mV/50 kΩ
–21 dBm to –15 dBm (660 nm ±30 nm)
DC 5 V
USB DC 5 V
DC 6 V
390 mm × 88 mm × 136 mm
4 Ω
500 mA
500 mA
1 A (DC IN)
0.5 kg
2