Basic Connection Example - JVC TM-2100PN Bedienungsanleitung

BASIC CONNECTION EXAMPLE

Notes:
• Before connecting your system, make sure that all units are turned off.
• The illustration below shows some examples of different connections. Terminal connections may differ depending on the
component connected. Be sure to refer to the instructions provided with the unit(s) you are connecting.
• Each pair of input (IN) and output (OUT) terminals are bridge-connected.
• If you're not connecting any equipment to a bridged output (OUT) terminal, be sure not to connect any other cables to the
bridged output (OUT) terminal as this will cause the terminating resistance switch to open (auto terminate function).
• When making a bridge connection, connect the input (IN) and output (OUT) terminals on the monitor to separate video
components.
(For example, if both terminals are connected to the same VCR, resonance may occur except during playback. This is caused by
the same video signal "looping" between the VCRs, and is not a malfunction.)
• Select the video input (Input A (VIDEO), Input B (Y/C) or Input B (VIDEO)) with the INPUT SELECT button on the front panel.
• The ASPECT RATIO or BRIGHTNESS P.S. function can be controlled via the REMOTE terminal. To do this, set REMOTE
SELECT in the <SET-UP MENU> mode. (Refer to pages 8 and 9.)
VIDEO A Connection Example
(Select Input A (VIDEO) button)
Video
(Video signal cable)
Video Camera
Video Monitor
Audio
(Audio signal cable)
VCR
External control switch
open circuit (open)
short circuit (short)
External control switch
External control
Open circuit
functions
(open)
ASPECT RATIO 4–3 (4:3)
BRIGHTNESS P.S. OFF
LCT0053-002A-H (EN)
VIDEO
AUDIO
REMOTE
REMOTE
(Remote cable)
RCA pin
Short circuit
(short)
16–9 (16:9)
ON
11
Video
A
IN OUT
(Video signal cable)
IN OUT
B
IN
Y/ C
OUT
Audio
A
IN
OUT (Audio signal cable)
B
IN OUT
IN
OUT
REMOTE
(Remote cable)
02.07.30, 2:46 PM
VCR
Video Monitor
– + B A
Y/ C VIDEO VIDEO
—OFF _ON
PHASE CHROMA BRIGHT CONTRAST MENU VOLUME/SELECT INPUT SELECT POWER
TM-2100PN
TM-2100PN
<second one>
: Signal Flow
11