PowerWalker DC UVS Bedienungsanleitung Seite 8

3.2 If the telemetry cable is not enclosed:
(1) Cut and strip the self-prepared cable leads, and then attach the
leads to the 7-position connector. Make sure that the correct
wire gauges are used for the safety (Please refer to "1.3 The 7
Pin Terminal Connecter Intro Table")
(2) Plug the 7-conductor cable into the outlet of the DC UPS
(3)Then place the cable between the two sticks for fixing the cable
as the following picture
4. Close the wire connection cover
5. Connect the other end of the cable to the equipment
EN
Page 8