Installation; Wire Connection - PowerWalker DC UVS Bedienungsanleitung

4. Installation

4.1 Wire Connection

1. Remove the wire connection cover in the rear of the DC UPS. Keep the
cover will and reinstall the cover after all the wires are well-connected.
2. Plug IEC-LOCAL power cord into the AC input socket on the back of DC
UPS. Do not connect the AC power cord to utility outlet prior to this
process.
3. Connect DC UPS to network device.
3.1 If the telemetry cable is enclosed:
(1) Plug the telemetry cable into the 7-position connector
(2) Then place the cable between the two sticks for fixing the cable as
the following picture
EN
Page 7