Technical Specifications - Kärcher SC 1.030 Kurzanleitung

Troubleshooting
Often, failures have simple causes and you
can do the troubleshooting yourself using
the following overview. If you are in doubt
or if the failure is not listed here please con-
tact the authorized customer service.
Danger
Always disconnect the mains plug and al-
low the steam cleaner to cool down before
performing any maintenance work.
Repair works may only be performed by the
authorized customer service.
Long heating-up time
Steam boiler is decalcified
 Descale the steam boiler.
No steam
No water in the steam boiler.
 Turn off the appliance.
 See „Refilling Water" Page 9.
Steam lever cannot be pressed
anymore
Steam switch is secured with the lock /
child-proof lock.
 Move the selector switch for the steam
volume to the front.
After breaks during ironing, water drops
will come out of the steam pressure iron.
During longer breaks from ironing, the
steam in the steam line can condense.
 Direct the first burst of steam at a sepa-
rate piece of cloth.
Steam iron "spits out" water!
 Set the thermostat to level •••.
 Rinse or decalcify the boiler of the
steam cleaner.
High water output
Steam chamber too full
 Press the steam gun until less water is
emitted.
Steam boiler is decalcified
 Descale the steam boiler.
22

Technical specifications

Electrical connection
Voltage
Protection class
Protective class
Performance data
Heating output
Heating output steam iron
Operating pressure max.
Heating time
Steam volume
Continuous steaming
Steam push max.
Dimensions
Boiler capacity
Length
Width
Height
Weight (without accessories) 2,9 kg
Subject to technical modifications!
– 13
EN
220-240 V
1~50/60 Hz
IP X4
I
1500 W
700 W
0,32 MPa
8 Minutes
40 g/min
100 g/min
1,0 l
380 mm
254 mm
260 mm