Herunterladen Inhalt Inhalt Diese Seite drucken

VOLTCRAFT V-CHARGE 80GPS Bedienungsanleitung Seite 75

Multifunktions-ladegerät
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

• The discharge current at the lower left of the display flashes. Change the discharging current using the button
"INC" or "DEC". Keep the respective button pressed for quick adjustment.
The maximum possible discharging current depends on the rechargeable battery type and number of cells.
The maximum discharging power is 10 W.
Confirm the discharging current with the "START/ENTER" button.
• The number of the cells in the lower right of the display flashes. Set the number of the cells with the button "INC"
or "DEC". Keep the respective button pressed for quick adjustment.
Depending on the cell number and the set discharge end voltage per cell (see above), the total voltage of the
connected rechargeable battery is calculated automatically (at the end of discharging).
Confirm the cell number with the "START/ENTER" button; the display stops flashing.
• When no display is flashing anymore, keep the "START/ENTER" button pushed (approx. 3 seconds), to start
discharging.
• After starting the discharging process, various information about the cur-
rent progress is shown in the display.
In the upper left, the rechargeable battery type and the cell number are dis-
played ("Li3S" = Lithium rechargeable battery with 3 cells); the discharging
current is shown in the upper middle and the current rechargeable battery
voltage in the upper right.
The lower left shows the current rechargeable battery programme ("DSC" = discharging rechargeable battery), the
middle the elapsed discharging time and the discharged capacity is mAh is displayed to the right of this.
If a multi-cell rechargeable battery is connected to the charger via the
balancer connections, you can switch between the normal display
and the display of the cell voltages during the discharge process by
repeatedly pressing the "INC" button.
• After completion of discharging, an audio signal is emitted (if it has not been turned off).
If you wish to cancel the discharging process, push the "ESC/MODE/STOP" button.
Li3S 1.0A 12.32V
DSC 012:43 00252
3.90V 3.92 3.89V
0.00V 0.00 0.00V
75

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis