Battery Replacement - GYS GYSPACK AUTO Betriebsanleitung

Translation of the original instructions

BATTERY REPLACEMENT

1
Product Battery
GYSPACK AUTO
6FM - 18
To replace the battery :
• First the booster must be disconnected form the power supply.
• The back panel must be unscrewed (9 screws) and removed.
• Once the back panel is removed, the battery front appears (cf illustration). The battery is connected to the GYSPACK AUTO at
two points : at the - terminal 1 and at the + terminal 2 . To remove the battery, remove the screw that enables the connection
between the battery and the GYSPACK AUTO.
When putting a new battery, make sure to observe the polarities of both the battery and the
GYSPACK AUTO/400. Terminal - on the left, terminal + on the right (cf illustration). Put the 2
screws and washers back, tighten the nuts (recommended torque wrench 4 N.m).
• Place the booster's backpanel screws back on.
GYSPACK AUTO / GYSPACK 400
Type Voltage (V)
Lead- acid battery
Capacity (Ah)
12 18
EN
2
Dimensions
Battery ref
(cm)
33 x 14 x 35 53139
15