Watching TV
Watching TV
1
2
1
Press 1 on the TV (top side) to switch on
the TV.
When the TV is in standby mode (the 1 (standby)
indicator on the TV (front) is red), press "/1 on
the remote to switch on the TV.
2
Press DIGITAL to switch to digital mode or
ANALOG to switch to analogue mode.
The channels available vary depending on the
mode.
12
GB
2
3
3
3
Press the number buttons or PROG +/- to
select a TV channel.
To select channel numbers 10 and above using the
number buttons, enter the second and third digits
within two seconds.
To select a digital channel using the Digital
Electronic Programme Guide (EPG), see page 15.
In digital mode
An information banner appears briefly. The
following icons may be indicated on the banner.
: Radio service
: Scrambled/Subscription service
:
Multiple audio languages available
: Subtitles available
: Subtitles available for the hearing impaired
: Recommended minimum age for current
programme (from 4 to 18 years)
:
Parental Lock
: Current programme is being recorded
Additional operations
To
Do this
Turn off the TV
Press "/1.
temporarily
(Standby mode)
Turn on the TV
Press %. Press 2 +/- to set the
from Standby mode
volume level.
without sound
Turn off the TV
Press 1 on the TV (top side).
Note
To disconnect the TV completely,
pull the plug from the mains.
Press 2 + (increase)/
Adjust the volume
- (decrease).
Press %. Press again to restore.
Mute the sound
Access the
Press
Programme index
channel, press
table (in analogue
mode only)
To access the Input signal index
table, see page 18.
. To select an analogue
F
f
/
, then press
.