Adjusting The Logo Mode - Activating The Preheat Function - INNOCIGS CUBOID 200W Bedienungsanleitung

INNOCIGS CUBOID 200W BATTERY – USING THE DEVICE
Adjusting the Logo Mode
Connect your Cuboid 200W to your computer and download the new firmware from
www.joyetech.com/mvr-software/. Open the folder, start the program and
click the „Logo" button to upload your desired picture. Please use a bmp-file with a maximum
resolution of 64 x 40 pixels. Press the fire button and the "up" button simultaneously to activate
one of the logo buttons "ON" / "OFF". To confirm your selection, press the fire button again.
Activating the Preheat Function
To enter this submenu, press the fire button and the "up" button simultaneously. Then activate
the "up" key and enter the "Preheat" menu. Press the fire button to toggle between "preheat po-
wer" (PWR) and "preheat duration" (TIME). To activate one of the modes press the "up" or "down"
key. To confirm your selection press the fire button once again.
39