Use - CASO DESIGN HD1000 Bedienungsanleitung

2. Please do not use the filter at this moment yet.
3. Fill the water tank with ca. 2 litres of water.
4. Remove the tray.
5. Place a large bowl in front of the device so that it collects the water that runs out of the
spout.
6. Start the device with 000 temperature setting until the device dispensed water with normal
temperature.
7. Start the device with maximum temperature setting and continuous water flow (see 13.2).
8. After round about 1 minute the calibration of boiling point is finished and the device works
steadily.
9. When the water tank is empty, the device beeps and the dislay shows E7.
10. Remove the plug from the wall outlet and let the device cool down.
11. Refill the water tank again with fresh water. The device is now ready to use.
Filter
Warning
► The filter is only intended to filter tap water. Do not use water of unknown quality or that
has been microbiologically impaired.
1. Remove the filter from all packaging. There may be a small residue of black carbon
particles in the bag or adhering to the cartridge body. This is normal. These particles are
harmless and will be washed off during the preparation process.
2. Soak the filter upright in water for 10 min.
3. Rinse the filter under running water for 10 sec.
4. The filter is now ready for use.
► The lifetime of the filter lasts about 4-6 weeks of normal use (filtering of approximately 150
l water in total).
► Store the replacement filter cartridges in a cool location, out of
direct sunlight and away from heat sources.

14.2 Use

1. Fill in water
1. Open the lid, fill the water tank with the desired amount of water.
2. Close the lid.
► The water level must be less than the Max level.
2. Obtain desired water
1. Make sure the plug is connected to the wall outlet.
Caso Heißwasserbereiter HD1000
Please note
Please note
28