Control Elements; Mounting The Mains Rectifier - Waeco CoolPower MPS 35 Einbau- Und Bedienungsanleitung

_MPS-35.book Seite 16 Dienstag, 8. April 2008 11:18 11

Mounting the mains rectifier

5.1

Control elements

Item
in fig. 1, page 3
1
2
3
4
6 Mounting the mains rectifier
If you wish to mount the mains rectifier in a fixed position, please observe the
following mounting instructions:
Caution!
a
Fix the mains rectifier in upright position only. In case you have to
install the rectifier in a different position put the rectifier in a fire
resistant housing to prevent any fire being roused to other objects
by hot plastic tripping through the air slots.
Do not mount the device
– In wet or damp environments
– In the vicinity of combustible materials
– In areas where there is a danger of explosions
Make sure the socket is near the device and is easily accessible.
The place of installation must be well-ventilated. A ventilation system
which is at least equivalent to the air openings in the device must be
present for installations in closed housings.
The air intake on the underside or the air outlet on the back of the device
must remain clear.
The installation surface must be level and sufficiently sturdy.
Fasten the mains rectifier with screws through the fastening holes in the
front and the rear of the device (fig. 1 4, page 3).
16
www.busse-yachtshop.de | info@busse-yachtshop.de
Explanation
Mains cable
Battery input terminals
Compressor output terminals
Fastening holes
CoolPower MPS35