Thomashilfen tGo Bedienungsanleitung Seite 20

User manual – tGo
Leg separator plate
The leg separator plate is attached to the rearmost element of the articulating arm, where the saddle is fitted. Fit the leg
separator plate either to the front or rear of the two locating holes in the rearmost element of the articulating arm. The
saddle must be removed before the leg separator plate can be attached. Push the leg separator plate into one of the
locating holes in the articulating arm from beneath. Secure the leg separator plate using the nut. Refit the saddle to the
tGo (for instructions on how to fit the saddle see section 4, "Setup and assembly").
Additional pad elements
The number of pads fitted to the tGo can be adjusted according to individual requirements. To fit additional pads,
the black plastic element – that has a slot in it for the belt – must first be removed. To do this, remove the screw that
connects the outer pad with the plastic element (the supplied Allen wrench and a 10 mm ring or open end wrench are
required).
Pull the black plastic element out of the pad. Push the desired number of pads onto the pad ring. Ensure that the black
plastic pad holders are always pointing away from the child's body. Always secure the pads using the supplied nuts and
screws. Finally, replace the belt guide components onto the pad ring and secure in-place.
Follow the same procedure for removing pads that are not required.
Installing and adjusting the seat-brake system
Assembly
To install the seat-brake system, the standard rear wheels have to be replaced with the rear wheels with integrated se-
at-brake system (available as accessories).This should only be done by a specialist dealer. In order to do so, the hexagon
screw that connects the frame of the tGo to each wheel has to be removed (Fig. 36). Now the standard wheels can be
replaced by the wheels with integrated seat-brake system. Ensure that the suspension is perpendicular to the floor during
installation (Fig. 38). Mount the wheels on the frame of the tGo using the hexagon screws.
If the weight of the child being fitted is very low, a spring may have to be removed from the seat-brake system.
In order to do so, remove the two Allen head screws from the wheel. Set the cap aside, remove one of the metal pins
and pull off the spring. (Fig. 37). Set the pin back into the fixture without the spring. Ensure that the spring of the other
pin is under tension in the recess. Position the cap with the round side facing down and screw it down tight. Before
using, ensure that the screws are firmly tightened.
Installing and adjusting the return stop
Assembly
To install the return stop, the standard rear wheels have to be replaced with the rear wheels with integrated return stop
(available as accessories). This should only be done by a specialist dealer. In order to do so, the hexagon screw that
connects the frame of the tGo to each wheel has to be removed (Fig. 36). Now the standard wheels can be replaced by
the wheels with integrated return stop. Install the wheels so that the plastic curve (Fig. 34) faces to the left respectively.
Insert the smaller metal spacer sleeves in this side. Install the wheel on the other side with the larger metal spacer slee-
ves (Fig. 35). Mount the wheels on the frame of the tGo using the hexagon screws. Before using, ensure that the screws
are firmly tightened.
Pull rod
The pull rod can be hooked into the plastic eye on the tGo frame when needed. (fig. 29)
20