Connections, Controls And Indicators - LD LDEB82AG3 Bedienungsanleitung

All Stinger G3 enclosures are made of rigid, low-resonance birch ply. They are coated with non-abrasive, impact resistant
®
polyurea for superior strength and unrivaled durability. Integrating LD Systems' Dual-Tilt pole mount, multiple suspension
points, stacking recesses and ergonomic handles the Stinger
companies and installation applications. The large selection of Stinger
hardware plus a stackable dolly board to facilitate transport. Isn't it time you saddled up?

CONNECTIONS, CONTROLS AND INDICATORS

3
2
1
6
1
INPUT LINE / MIC CH 1 & 2
Balanced microphone or line input (XLR / 6.3 mm jack combo) for channels 1 and 2 (CH 1 + CH 2). It is also possible to use unbalanced
microphone cables (Mono jack). Switching to the corresponding setting is done using the MIC / LINE N 3 switch.
2 GAIN CH 1 & 2
Volume controller for channels 1 and 2 (CH 1 + CH 2). Turning the controller to the left decreases the volume; turning it to the right increases it.
3
LINE / MIC
Switch for switching the input impedance and the signal boost for channels 1 and 2 (CH 1 + CH 2). Please set the volume controller of the
corresponding channel to minimum (left stop) before connecting a playback device or microphone. To connect a playback device with a
line level (e.g. mixer, keyboard), select the LINE setting (LED indicator MIC is not lit); to connect a microphone, select the MIC setting (LED
indicator MIC is lit).
4 MODE
Switch to switch between DSP presets. The different presets are retrieved by repeatedly pressing the switch (check the LED indicator).
FULL-RANGE: Preset for operating the loudspeaker without any additional subwoofer (bass boost, presence cut and treble boost).
SATELLITE: Optimal setting for operating with a subwoofer (high-pass filter at 90 hertz, presence cutback and treble boost).
MONITOR: Preset for operating the speaker as a stage monitor (bass cutback to compensate for ground coupling,
treble cutback for optimum, prominent sound at close range).
FLAT: Linear frequency response in DSP preset when using an external equaliser for manual adjustment to the sound situation at hand.
4
5
3
2
1
G3 Series has been designed for touring musicians, rental
®
accessories includes smart wall and truss mounting
®
8
7
5