Using The Battery Charger; Using Accessories; Storing The Battery Charger In The Wall Bracket - Dometic MCP1204 Bedienungsanleitung

PerfectCharge MCP1204/1207
7.2

Using the battery charger

➤ Select the required mode:
Mode 1 (battery is connected): Press the button for 1 s.
Mode 2 (battery is connected): Press the button for 5 s.
Mode 3 (battery is not connected): Press the button for 10 s.
✓ The charging process starts in mode 1 and 2.
A constant voltage supply is started in mode 3.
✓ The LEDs show the charging progress of the battery of the battery charger (see
chapter "Status indications" on page 14).
➤ To end the charging process, press the button once again.
I
NOTE
When the red LED flashes because the battery voltage is under 9 V, you
can charge the battery to over 9 V in mode 3. To do this, disconnect the
battery and switch to mode 3. Once the battery has been charged over
9 V, you can switch the battery charger to mode 1 or 2 again to start
normal charging.
8

Using accessories

I
NOTE
Accessories are not included in the scope of delivery.
If you have questions regarding the accessories, please contact your
local service partner.
8.1

Storing the battery charger in the wall bracket

Installation instructions
When selecting the installation location for the wall bracket, observe the following
information:
• The wall bracket must be installed in a location protected from moisture.
• The wall bracket may not be installed in areas containing flammable materials.
• The wall bracket may not be installed in dusty environments.
• The device must be installed on a level and sufficiently sturdy surface.
EN
Using accessories
17