Safety Instructions And Danger Warnings - Conrad McCrypt DJ 5C/2 Bedienungsanleitung

Safety instructions and danger warnings

The guarantee will lapse in case of damage caused by failure to
comply with these operating instructions! We shall not be liable
for any consequent loss!
We do not take any responsibility for personal injury and damage
to property caused by incorrect handling or non-observance of
the safety instructions! The warranty will lapse in such cases.
For safety and licensing reasons (CE), any arbitrary conversion and/or
modification of the system is not permitted.
The device may not be exposed to extreme temperatures (<+10°C /
>+35°C).
The device may not be exposed to strong vibrations or heavy mechan-
ical stress.
The device may not be exposed to excessive dampness such as, for
example, dripping or spray water.
The device is constructed according to protective class II.
The system is only licensed for operation in closed rooms.
Do not place vessels such as glasses, vases etc. on the device. Never
pour out liquids above the device.
Never place small objects, e.g. coins, paper clips etc., on the device
as these could fall into the inside of the device. There is the danger of
fire or a fatal electric shock! If any liquid penetrates into the device, pull
out the mains plug immediately and contact a specialist.
30
Problem Possible cause
The operating display No input signal
lights up but no tone Input connected
can be heard. incorrectly or not at all
Input level set incorrectly
MASTER fader is in
position "0".
Channel faders are in
position "0"
No signal can be heard Downstream device not
although the level switched on or
display indicates incorrectly set
a signal Output incorrectly
connected or not at all
Input level set incorrectly
Buzzing sound A cable is defective
can be heard. A buzz loop arises
between the
connected devices
A channel does Connection cable has
not function worked loose.
The balance control on
the amplifier is out of
adjustment
Tone is distorted Mixer output is incorrectly Set mixer output as
set or the connected
amplifier is overmodulated
Connected device does
not adhere to the required appropriate connection
specification for a cinch
connection or does not
possess the appropriate
connections
Control GAIN
incorrectly adjusted, the
mixer is overmodulated
Elimination of the fault
Check the signal source
Connect input correctly
Set level using the control
"GAIN" as described
Set MASTER fader
correctly
Set channel faders
correctly
Check downstream device,
select correct input
on the amplifier
Connect output as
described
Set mixer in/output level
as described
Replace cable
Connect signal earth by
means of special
earth-insulated cable.
Check connections
between the devices
Set balance control on
amplifier
described
Use device with the
Set mixer input
as described
47