Unpacking - Repackaging; Cleaning; Replacing The Battery Or Fuses - Metrix MX 22 Bedienungsanleitung

1.6 Unpacking - Repackaging

This equipment has been fully checked out mechanically and
electrically before shipping.
All precautions have been taken to ensure that the instrument arrives
at its destination undamaged.
However, it is advisable to carry out a rapid check for damage
sustained in shipping. If there is any evidence of damage, make this
known immediately to the shipper.
Should you need to return the multimeter, preferably use the
original packaging and indicate the reasons as clearly as
possible on an accompanying note.
1.7

Cleaning

Clean the instrument using a damp cloth and soap. Never use
abrasive or solvents.
1.8

Replacing the battery or fuses

First disconnect test leads from any circuit under test, turn the
meter off and remove test leads from the input terminals .
Use the following procedure :
1 - Using an appropriate tool, slide off the case bottom of the
instrument.
2 - Replace the battery or the fuse.
3 - Replace the removable part.
F1 0.63 A, HBC
18 kA / 600 V
HBC fuses must be replaced by fuses of the same rating and type.
18
F2 10 A, HBC
50 kA / 600 V
BATTERY 9 V
6LF22
Portable 4000 count digital multimeter