Issuing Commands Via The Op1S - Siemens OP1S Betriebsanleitung

OP1S Operator Control Panel

3.9 Issuing commands via the OP1S

Control functions and setpoint specifications for the connected unit can be selected with
the corresponding keys of the OP1S, for example during start-up. To do so, the sources
of the control commands have to be added to the corresponding bits of word 1 of the
SCom1 interface. For setpoint specification, the sources of the setpoints must be
appropriately "interconnected". In addition, the setpoint to be changed is to be
parameterized as a displayed value in the 3rd line of the operating display.
Key Function
ON / OFF1
Motor potentiometer: setpoint higher,
lower (only effective within the operating
display)
Setpoint specification by means of fixed
0 9
bis
setpoint (only effective within the
operating display. If entered with
or
numerical key, confirm with "P")
Reversing
Acknowledging (only effective within the
operating display)
Jogging with jog setpoint 1 (only effective
in the "Ready" state
NOTE The OFF function can also be performed with OFF2 or OFF3 instead of
OFF1. For this, the source of OFF2 or OFF3 must be appropriately
"interconnected" in addition to setting ON/OFF1.
Siemens AG 477 459 4070 76 J AA-74
SIMOVERT MASTERDRIVES Operating Instructions
21