Manufacturer's Warranty; Spare Parts Lists - REMS Curvo Betriebsanleitung

eng
5. Faults
5.1. Fault: Bending former sticks during bending although the motor is running.
Cause:
● Pipe with too great wall thickness bent.
● Slip clutch worn.
● Carbon brushes worn (REMS Curvo, REMS Curvo 50).
● Battery flat or defective (REMS Akku-Curvo).
5.2. Fault: Bend is out of round.
Cause:
● Wrong bending former/back former.
● Worn back former.
● Damaged pipe.
5.3. Fault: Pipe slips out of the driver (10) during bending.
Cause:
● Driver bent or worn.
● Pipe does not protrude far enough out of the driver.
5.4. Fault: Device does not start.
Cause:
● Mains lead defective.
● Device defective.
● Carbon brushes worn (REMS Curvo, REMS Curvo 50).
● Battery flat or defective (REMS Akku-Curvo).
6. Disposal
The drive units, batteries and rapid chargers may not be thrown in the house-
hold waste when they are finished with. They must be disposed of according
to the legal regulations. Lithium batteries and battery packs of all battery systems
may only be disposed of in the discharged state, all contacts of incompletely
discharged lithium batteries and battery packs must be covered with insulating
tape.
7. Manufacturer's Warranty
The warranty period shall be 12 months from delivery of the new product to the
first user. The date of delivery shall be documented by the submission of the
original purchase documents, which must include the date of purchase and the
designation of the product. All functional defects occurring within the warranty
period, which are clearly the consequence of defects in production or materials,
will be remedied free of charge. The remedy of defects shall not extend or
renew the warranty period for the product. Damage attributable to natural wear
and tear, incorrect treatment or misuse, failure to observe the operational
instructions, unsuitable operating materials, excessive demand, use for unau-
thorized purposes, interventions by the customer or a third party or other
reasons, for which REMS is not responsible, shall be excluded from the warranty
Services under the warranty may only be provided by customer service stations
authorized for this purpose by REMS. Complaints will only be accepted if the
product is returned to a customer service station authorized by REMS without
prior interference in an unassembled condition. Replaced products and parts
shall become the property of REMS.
The user shall be responsible for the cost of shipping and returning the product.
The legal rights of the user, in particular the right to make claims against the
seller under the warranty terms, shall not be affected. This manufacturer's
warranty only applies for new products which are purchased in the European
Union, in Norway or in Switzerland.
This warranty is subject to German law with the exclusion of the United Nations
Convention on Contracts for the International Sales of Goods (CISG).

8. Spare parts lists

For spare parts lists, see www.rems.de → Downloads → Parts lists.
14
REMS Curvo / REMS Curvo 50 / REMS Akku-Curvo
Remedy:
● Only use approved pipes.
● Have the slip clutch replaced by qualified personnel or an authorised REMS
customer service workshop.
● Have the carbon brushes changed by qualified personnel or an authorised
REMS customer service workshop.
● Charge the battery with the Li-Ion/Ni-Cd rapid charger or change the battery.
Remedy:
● Use the appropriate bending former/back former for the pipe.
● Change back former.
● Only use undamaged pipes.
Remedy:
● Change bending former (1).
● Place pipe in the bending former so that the pipe end protrudes at least 10 mm
beyond the driver.
Remedy:
● Have the mains lead changed by qualified personnel or an authorised REMS
customer service workshop.
● Have the device repaired/serviced by qualified personnel or an authorised
REMS customer service workshop.
● Have the carbon brushes changed by qualified personnel or an authorised
REMS customer service workshop.
● Charge the battery with the Li-Ion/Ni-Cd rapid charger or change the battery.
eng