Disposal / Recycling; Warranty - Brill Brillencio 43 BRe-comfort Gebrauchsanweisung

Keep your fingers and feet away
from the cutting tool!
GB
Never lift or carry a machine with
the motor running.
Each time you have to work on
the machine or leave it or top it up,
always switch off the motor.
If you strike an obstacle when
working, please disable the
machine. Remove the spark plug.
Remove the obstacle, check the
equipment for any damage and
have it repaired if necessary.
If the equipment begins to vibrate
strongly, remove the spark plug
and ascertain the cause.
Charge the power pack prior to
first start-up for a full 24 hours
please.
Never recharge the power pack
after it has been heated up
by being used or by sunlight.
Let cool down first.
During charging, the mains plug
and the power pack will slightly
warm up.
Only use the charger in dry rooms
and never in direct sunlight.

12. Disposal / recycling

Ni-Cd
These Accus contain nickel-
cadmium cells. After their life-

Warranty

The manufacturer warrants its prod-
ucts for exclusively non-commercial
use for a period of 24 months from
the date of original purchase.
This warranty does not affect
statutory warranty claims. The war-
ranty covers all substantial faults of
the product, which are caused by
defects in material and workman-
ship. If a product exhibits such a
defect we will, at our option, repair
28
Make sure that no easily inflam-
mable substances are located next
to the appliance during charging.
Only charge the Brill power pack
A12(e) with the Brill charger LG12.
If you operate peripheral equip-
ment, first unplug the charger from
the power pack.
As a user of the appliance, you are
responsible for Third parties in your
range of action.
Never leave the Power pack
plugged in for more than
24 hours, otherwise its life
will be shortened.
Only use the Power pack for the
periphery equipment intended for
such use.
Under extreme conditions, some
liquid could leak out of the
Power pack. But this does not
mean that it is defect.
Proceed as follows if the case
should leak for such reasons:
1. Wash all affected skin parts
with water and soap.
2. Neutralise the Power pack
liquid with a little vinegar or
lemon juice.
time have expired, they may not
be disposed of as normal house
rubbish, but must be disposed of
properly. Please return PowerAccus
to a Brill dealer that sells the
or replace it without cost for parts
and labour provided the following
requirements are fulfilled:
The product must have been
.
sold to the customer in a legally
correct way.
The original receipt with the
.
customer's address, date of
purchase, model and product
designation is presented as
proof of purchase. The product
3. If any liquid has entered your
eyes, thoroughly rinse them
with clear water for at least
10 minutes. Then consult a doc-
tor immediately.
Never throw any old power packs
into the open fire.
Risk of explosion!
Make sure that the contacts are
never bypassed with metallic or
other electrically conductive parts.
Short-circuit – risk of fire!
A
Taking a Break
Never leave the equipment
unattended. If you stop work,
switch the machine off and
remove the spark plug.
If you stop work to go to a different
work area, it is essential to turn the
equipment off and remove the
spark plug.
Beware of Environmental
A
Influences
Never use the equipment in the rain
or in damp, wet conditions.
Comply with local quiet periods in
your community!
Power-Accu 24-Volt System or take
them to a recycling centre that
accepts and recycles rechargeable
batteries.
must have been purchased
within the EC.
The product was handled proper-
.
ly and according to the recom-
mendations in the operating
instructions. It is essential that the
product has been maintained and
cleaned according to the informa-
tion in the operating instructions.
No attempt to disassemble or
repair the product has been